Sangean RCR-2 (V1) Bedienungsanleitung PDF herunterladen (Seite 10)

If the symbol blinks irregularly, try to improve the reception of the

radio controlled time signal by re-allocating the radio, or rotate or

extend the external antenna. If the time signal can not be received in

your area, you will have to set the time and date manually.

Note :

To activate radio controlled time check manually, press Time button 9

for more than 4 seconds, the appliance will start to search radio

controlled time signal.

Manual time setting

TIME

Press TIME button, display will flash and previous allocated time.

Press SET button, the Hour digits in the time display begin to blink

with a beep.

1. Adjust the hour with key + or - .

2. Press the SET button once again to confirm the hour, now the

minute digits in the time display begin to blink.

Adjust the minutes just as you adjusted the hour:

1. Set the minutes with key + or -.

2. Press the TIME button once again to confirm the time setting with

a beep.

The second starts to count. The symbol will appear indicating this

is not radio controlled time.

Note:

If there is Daylight Saving Time ( D.S.T.) system in your place,

after pressing SET button, press Mode button once will

advance one hour on time setting, Display will show D.S.T.

symbol indicating the time is under D.S.T. status.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

Sangean RCR-2 (V1) Bedienungsanleitung Seite 10